The cavity pressure steering system has been installed in our injection moulding tool! This allows us to map the flow of the polymer slurry through the entire inlet system of the mould! When producing standard test specimens, it is essential to document the correct parameters in order to produce specimens with the best possible properties. We have completed a lengthy design/build and development project.
Participants in the design/execution: Attila Bata, Gergely Tóth
Thanks to Cavity Eye Hungary Kft. for the offer of the dipping equipment and for the continuous technological assurance!
Total cost of the Cavity Eye system: 10.000 EUR
Thank you Dr. András Szűcs!
